X-ray micro-tomography based FEM modelling of hygroexpansion in PLA composites reinforced with birch pulp fibers

Kirjoittajat

  • Stefania Fortino VTT Technical Research Centre of Finland Ltd
  • Merja Sippola
  • Tom Andersson
  • Kirsi Immonen
  • Arttu Miettinen
  • Petr Hradil

DOI:

https://doi.org/10.23998/rm.65042

Avainsanat:

PLA composites, wooden fibers, hygroexpansion, X-ray micro-tomography, image-based modeling

Abstrakti

This article presents a microscale modelling approach coupled with X-ray computed micro-tomography for the evaluation of material properties of polylactic acid (PLA) reinforced by birch pulp fibers under the effect of moisture. The results in terms of elastic moduli and hygroexpansion deformation were found in good agreement with the measurements taken at different levels of water uptake.

Tiedostolataukset

Julkaistu

2017-08-21

Numero

Vol 50 Nro 3 (2017)

Osasto

Artikkelit

Lisenssi

Copyright (c) 2017 Stefania Fortino, Merja Sippola, Tom Andersson, Kirsi Immonen, Arttu Miettinen, Petr Hradil

Creative Commons License

Tämä työ on lisensoitu Creative Commons Nimeä-JaaSamoin 4.0 Kansainvälinen Julkinen-lisenssillä.

Viittaaminen

Fortino, S., Sippola, M., Andersson, T., Immonen, K., Miettinen, A., & Hradil, P. (2017). X-ray micro-tomography based FEM modelling of hygroexpansion in PLA composites reinforced with birch pulp fibers. Rakenteiden Mekaniikka, 50(3), 131-136. https://doi.org/10.23998/rm.65042